The Main support is up. It is important that the main post are Square.
This is a illustration of how to square the poles. I painted the lines of the wall on the ground to make it easier to find where to dig the holes.
The roof panels are done. Note the spaces left open, they are for the the different angles of the walls connecting to the roof. All the holes for the holds are drilled before installing the panels.
A different view of the roof panels going up
The 2×4’s are up for the walls.
A look at the steeper side.
All but one of the panels are up on the vertical wall. we used 2” wood screws to fasten the plywood to the 2×4’s.
The first 2 panels on the steep wall. We decided to drill the holes in an 8” on center pattern.
A look between the different angled walls to the roof. Joist Hangers are used to connect the 2×4’s on the roof.
The top side of the roof. By the way, there are the 3” screws I was looking for.
The filler panel is cut and installed.
Another view of the wall panels (little blurry). I will continue with the pics as soon as we get some holds.
If you enjoyed this post, make sure you subscribe to my RSS feed!
